问答 #17454 - 11.1 Schematic - In the RTL Viewer, an instantiated core does not appear to be connected
11.1 Schematic - In the RTL Viewer, an instantiated core does not appear to be connected
| 问答编号# | 17454 |
| 型号 | SW-Schematic |
| 最后更新日期 | 2009-08-06 00:00:00.0 |
| 记录状态 | Active |
| 关键词 | XST, read, viewer, CORE Generator |
疑问描述
Keywords: XST, read, viewer, CORE Generator
When I view a schematic of my design RTL in the RTL Viewer, a core that was instantiated in the design does not show nets connected to the symbol representing the core.
解决方案
This is typically a visual-only problem that occurs during the creation of the RTL schematic. To verify that a core has been connected correctly after implementation, use the FPGA Editor.If you are using ISE 6.2i or earlier, a possible cause of the "missing nets" in the RTL view is related to the "Read Cores" option for XST. When this option is selected ("On"), the core will not be connected in the RTL view. You can resolve this issue by unchecking this option and running synthesis again. After you perform these steps, the core will be connected.
If you are using the latest software version, please report any missing or incorrect connections to Xilinx Technical Support and provide a test case if possible.
http://www.xilinx.com/support/