问答 #22648 - 10.1 iMPACT - Installing Xilinx cable drivers on Linux operating system/kernel version 2.6
10.1 iMPACT - Installing Xilinx cable drivers on Linux operating system/kernel version 2.6
| 问答编号# | 22648 |
| 型号 | Config-iMPACT |
| 最后更新日期 | 2009-07-09 00:00:00.0 |
| 记录状态 | Active |
| 关键词 | operation, windrvr6, windrvr.o, mismatch, compiled, cable, parallel, platform, USB, 9.2i, 9.1i |
疑问描述
Keywords: operation, windrvr6, windrvr.o, mismatch, compiled, cable, parallel, platform, USB, 9.2i, 9.1i
Before a design tool can communicate with any Xilinx cable (e.g., Platform Cable USB, Parallel Cable IV, etc.), Xilinx cable drivers must be recompiled for the host system's Linux kernel version and then installed. Otherwise, the cable will not connect and the design tool will generate one or more of the following error messages:
"Module windrvr6 is not loaded. Please reinstall the cable drivers. See Xilinx Answer Record 22648."
"Please update to WinDriver version 8.02 or later. See Xilinx Answer Record 22648."
"/lib/modules/misc/windrvr6.o: kernel-module version mismatch
/lib/modules/misc/windrvr6.o was compiled for kernel version xxxxxx, while this kernel is version xxxxxx"
"insmod: error inserting lib/modules/misc/windrvr6.o: -1 Invalid module format "
解决方案
Please refer to the "USB Cable Installation Guide" (UG344) and the install_drivers.tar.gz archive, which can be located at:http://www.xilinx.com/support/documentation/configuration_hardware.htm
**Check that the fxload application is installed on your Linux install before installing drivers.