问答 #33423 - ISE Simulator (ISim) - Error "Simulator is abnormally terminated"

问答编号#	33423
型号	SW-ISE Simulator
最后更新日期	2009-10-30 00:00:00.0
记录状态	Active
关键词	simulator termination

解决方案 1

This error can also occur if the simulator engine cannot allocate sufficient memory during elaboration of a large design. This is particularly applicable to Post-Route simulations due to the large structural netlist and timing back-annotation. Additionally, this issue occurs mostly on Windows 32-bit machines as the 32-bit kernal can only allocate 2 GB per process; refer to (Xilinx Answer 14932).

To resolve this issue:
1. Run the simulation on a Linux 32-bit system; as the Linux 32-bit kernel can allocate up to 4 GB of memory.
2. Run the simulation on a Windows 64-bit system.
3. Follow the instructions in (Xilinx Answer 14932) to enable 3 GB application support (Windows XP only).

This issue is currently under investigation to better address this condition in a future release of the ISE Simulator.

解决方案 2

This error can occur if there were syntax errors or problems while running the simulator executable.

For more details, review the ISim log (isim.log) available in the project directory (or working directory, if launching simulation in batch mode).

This issue is currently under investigation to better address this condition in a future release of the ISE Simulator.

If the information contained in the log file does not help you address the problem, open a WebCase with Xilinx Technical Support for further assistance:
http://www.xilinx.com/support/clearexpress/websupport.htm