AR# 10332


3.1i FPGA Editor - If I change an IOB's I/O standard and attempt to exit, the edited IOB causes the program to shut down


Keywords: FPGA Editor, IOB, close, Virtex-E, crash

Urgency: Standard

General Description:
If I open a project in FPGA Editor and edit an IOB's I/O standard, the software will exit when pushing out of the IOB. No warning or error is issued. (This has been seen with both Windows NT and Solaris versions of FPGA Editor.)

NOTE: This problem occurs if I attempt to leave the IOB either with or without saving my changes.


This problem was fixed in the 4.1i software, which was released in September, 2001.
AR# 10332
日期 08/15/2002
状态 Archive
Type 综合文章
People Also Viewed