AR# 13659


Virtex-II, Speed file - The TIOPICK/TIOICKP (IOB register setup/hold) reported in TRCE/Timing Analyzer does not match the data sheet (data valid window)


General Description:

When I generate a timing constraint, in the TWR/TWX timing report, the setup/hold time of input register does not match the data sheet number.

The TRCE report (TWX or TWR file) shows that the IOB register setup/hold window is 200 ps (using Virtex-II 1.94 speed files for -5 in an XC2V6000), as follows:

 Setup/Hold time report
Setup/Hold time report

This does not match the TIOPICK/TIOICKP (pad, no delay) stated in Table 14, page 9 of the data sheet:

The data sheet number for Virtex-II -5 is:

TIOPICK: 0.96 ns

TIOICKP: - 0.39 ns

In addition, the TPSDCM does not match. TRCE reported the following in TWX/TWR file:

 IOB setup time using DCM in timing report
IOB setup time using DCM in timing report

Based on the report:

TPSDCM = 1.175 (data path) - ( - 0.505) (clock path) = 1.67 ns.

No TPHDCM report.

On page 25 of the Data Book, Table 31 ( reports the TPSDCM/TPHDCM for 2V6000-5 as: 1.70/-0.9 ns.


This is a resolved known issue -- TRCE and Timing Analyzer were not reporting these numbers correctly. The data sheet numbers for setup/hold times are correct.

This problem is fixed in the latest 4.2i Service Pack, available at:
The first service pack containing the fix is 4.2i Service Pack 3.

AR# 13659
日期 01/18/2010
状态 Archive
Type 综合文章
People Also Viewed