We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 15054

Virtex-II Pro RocketIO - Behavior of AVCCAUX (RX/TX) supply currents at device power up before VCCINT and VCCAUX supplies are powered up


At power up, AVCCAUX (RX/TX) supplies can sink current when VCCINT and VCCAUX are not powered up.


At power up, the RocketIO are placed in power down mode by default. However, the default POWERDOWN mode control signal originates from the digital circuitry of the RocketIO in the VCCINT supply domain. In addition, the default power down control signal passes through a translation stage in the VCCAUX supply domain. Consequently, in order for the default power down mode to take effect at power up, both the VCCINT and VCCAUX supplies must be present. 


RocketIO POWERDOWN Control
RocketIO POWERDOWN Control


For this reason, you can see current in the AVCCAUX (RX/TX) supplies because until both VCCINT and VCCAUX supplies are present, the RocketIO might be fully alive.  



If the RocketIO is not used in your design and the potential current is not needed, you can limit the current with a current-limiting resistor. 


To minimize the current draw, a range of 8-12 mA is recommended. 


For example: 

Current Limit (I) = 10 mA 

Worst Case Voltage Drop across Resistor (v)= 2.5V 

Resistor Value = 2.5/10 mA = 250 ohms 


NOTE: Once VCCINT and VCCAUX power up, the default POWERDOWN mode signal is active and AVCCAUX (RX/TX)s will not draw current.

AR# 15054
日期 05/14/2014
状态 Archive
Type 综合文章