We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 17334

System Generator for DSP and XtremeDSP Development Kit - How do I run the XtremeDSP Kit USB Hardware in the loop simulation?


General Description: 

How do I run the XtremeDSP Kit USB Hardware in the loop simulation? 


For information on the XtremeDSP Kit PCI Hardware in the loop Simulation, see (Xilinx Answer 18794).


Follow these steps to make sure that the XtremeDSP Kit or XtremeDSP Kit-II is properly set up: 

1. To open the FUSE Software, select Programs -> FUSE -> Software -> FUSE Probe. 

2. To open the XtremeDSP Kit Card, select Card Control -> Open Card. 

3. The default Interface should be set to USB. Press Locate Cards. 

4. The FUSE Software should detect the card and return the Serial Number. Press Open Cards. 

5. Once the card is opened, you should see a picture on the left, along with a product tree that lists the BenONE and BenADDA card. 

6. Close the FUSE Software, making sure to close all of the cards. 

7. If the card is working, you can proceed with the Hardware Co-Simulation. 


System Generator for DSP Hardware in the Loop 

1. Double-click the SysGen token. 

2. From the compilation drop-down menu, select XtremeDSP Development Kit -> PCI USB. 

3. Click Generate to generate the Hardware In The Loop library symbol. 

4. Drop the Symbol into your design. 

5. Double-click the XtremeDSP symbol. 

6. Select "Free Running" Clock from the drop-down menu. 

NOTE: USB simulation with the XtremeDSP Kit is only supported for the Free Running Clock mode. Xilinx recommends that you use PCI or JTAG Hardware in the loop. 

7. Select "USB" from the Bus Type drop-down menu. 

8. Click OK. 

9. Press Play in Simulink to start the simulation.

AR# 17334
日期 05/15/2014
状态 Archive
Type 综合文章