UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 17828

5.2i MAP - "ERROR:Pack:1107 when using Modular Design with PULLUP or PULLDOWN constraints"

描述

Keywords: area group, module, pull, pack, ngdbuild, constraint, IOB, net

Urgency: Standard

General Description:
When I use the PULLUP or PULLDOWN constraint with Modular Design, the following error message occurs during map:

ERROR:Pack:1107 - Unable to combine the following symbols into a single IOB component:
PAD symbol "module/net(0)" (Pad Signal = net(0))
BUF symbol "module/ibuf_1/IBUF" (Output Signal = module/net_in(0))
PULL symbol "net(0)_PULLDOWN" (Output Signal = net(0))
Modular design constraints prohibit the combination.

解决方案

This error is due to the fact that when using the PULLUP/PULLDOWN constraint, NGDBuild cannot place the component in the same module as the other components. Therefore, the PULLUP/PULLDOWN components need to be instantiated in the same module as the net they are attached to.
AR# 17828
日期 08/26/2003
状态 Archive
Type 综合文章
的页面