UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!
的页面
  1. 赛灵思 - All Programmable
  2. 技术支持
  3. AR# 1799: XABEL-CPLD: "Done: failed with exit code: 0003" when running Fitter

AR# 1799

XABEL-CPLD: "Done: failed with exit code: 0003" when running Fitter

Description

Keywords: XABEL, CPLD, exit, 0003

Urgency: Standard

General Description:
When compiling ABEL code through XABEL-CPLD, you may encounter
the following error message:

Starting: 'D:\XABEL6\syndos -pause -env @xact9k.env hitop -f >trigger.xtf
-s -l automake.err -o trigger'

Done: failed with exit code: 0003.
Set 'Observe and Pause' under the Options, Environment menu.
Then re-run the process for more information.

解决方案

1

This can happen if you use Abel language keywords as signal
or symbolic state names in your Abel code. Refer to the
XABEL-CPLD ABEL-HDL Language Syntax section of the online Help
which lists all the reserved keywords. Avoid using these
keywords as signal or symbolic state names.



2

Make sure that you have installed the latest patches for
XABEL-CPLD. The patches are fitterpc.zip and eztag_pc.zip and
are currently available on the Xilinx FTP site:

(Xilinx File http://www.xilinx.com/txpatches/pub/swhelp/cpld/fitterpc.zip)

(Xilinx File http://www.xilinx.com/txpatches/pub/swhelp/cpld/eztag_pc.zip)
AR# 1799
日期 08/27/2001
状态 Archive
Type 综合文章