We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 19826

Spartan-3 - Will the weak-keeper circuitry at the I/Os function with DCI-terminated standards?


Keywords: Spartan-3, weak, keeper, I/O, IO, terminate, termination, bus, hold, DCI, XCITE, pullup, pull-up, pulldown, pull-down, resistor

The keeper circuitry is designed to hold a bus at a known value in the event that all drivers on that bus are disabled. The circuitry essentially consists of a pull-up or pull-down resistor. Will this feature work in the presence of DCI termination?


The keeper circuitry works on all I/Os (DCI or non-DCI) that are series terminated, such as LVTTL and LVCMOS. However, any parallel termination resistors (e.g., those used with SSTL or HSTL standards) prevent the keeper from performing its function because it is not as strong as the 50 Ohm pull-ups/downs.

In addition, since the keeper upsets the balance of such terminations, it is not activated for the DCI standards employing parallel termination (although the software might indicate this by accepting the KEEPER attribute without issuing an error message).
AR# 19826
日期 09/12/2007
状态 Active
Type 综合文章