We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 19832

Spartan-3/-3E DCM - Is a timing diagram that illustrates variable phase shift (DPS) available? (Timing parameter for PSEN, PSINCDEC, PSCLK, and PSDONE)


Is a timing diagram that illustrates variable phase shift available?

Are timing parameters (setup/hold and clock-to-out) for PSINCDEC, PSCLK, and PSDONE with respect to PSCLK available?


The following timing diagram illustrates variable phase shift:

DFS Variable Mode Timing Diagram
DFS Variable Mode Timing Diagram

As shown above, all variable phase shift control and status signals are synchronous to the rising edge of PSCLK.

Specific timing parameters for PSINCDEC, PSEN, PSCLK, and PSDONE are not available. Since timing relative to PSCLK is 100% synchronous, PSEN, PSINCDEC, and PSDONE must be registered by PSCLK (rising edge) to ensure correct functionality.

PSEN must be active for exactly one clock period; otherwise, a single increment/decrement of phase shift is not guaranteed.

PSDONE is High for exactly one clock period when the phase shift is complete. The time required for a complete phase shift will vary. As a result, PSDONE must be monitored for phase shift status.

Between enabling PSEN until PSDONE is flagged, the DCM output clocks will slide bit by bit from their original phase shift to the incremented phase shift. The increment/decrement will be ready by PSDONE.

NOTE: When PSEN is triggered after the phase shift counter has reached the maximum value (255), the PSDONE will still be High for one PSCLK period some time after the PSEN is triggered (as illustrated in the figure above). However, the "Phase Shift Overflow" pin (STATUS(0)) will be High to flag this condition, and no phase adjustment is performed.

See (Xilinx Answer 19833) for more information about the (STATUS(0)) pin.

See (Xilinx Answer 19835) for more information about other DCM STATUS pins.

AR# 19832
日期 12/15/2012
状态 Active
Type 综合文章