UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 20950

Spartan-3/E - Can I leave HSWAP_EN unconnected? Does HSWAP_EN have an internal pull-up prior to configuration?

描述

Can I leave HSWAP_EN unconnected if it is not used? Does HSWAP_EN have an internal pull-up prior to configuration?

解决方案

HSWAP_EN has an internal pull-up prior to configuration. The strength of the pull-up is defined by Irpu in the device data sheet. For Spartan-3 this internal pull-up is strong enough to hold the pin High so no external resistor is needed. For Spartan-3E the internal pull-up is weaker so extra precaution can be taken by adding a stronger external pull-up to ensure a logic level High.

For more information on hot swapping Spartan-3 devices, see (Xilinx Answer 19777).

The DC and Switching Characteristic datasheet for Spartan-3 can be found at:

http://www.support.xilinx.com/xlnx/xweb/xil_publications_display.jsp?sGlobalNavPick=&sSecondaryNavPick=&category=-1209725&iLanguageID=1

The DC and Switching Characteristic datasheet for Spartan-3E can be found at:

http://www.support.xilinx.com/xlnx/xweb/xil_publications_display.jsp?sGlobalNavPick=&sSecondaryNavPick=&category=-1211389&iLanguageID=1

AR# 20950
日期 12/15/2012
状态 Active
Type 综合文章
的页面