AR# 22293


Parallel Cable IV - "ERROR: Device Control LPT_WRITE_CMD_BUFFER Failed"


When I use the Parallel-IV cable, the following error appears in the iMPACT log window:

"DeviceIoControl LPT_WRITE_CMD_BUFFER Failed."

Why does this occur?


This is an intermittent problem that some computers have with the cables.

This problem occurs only because of an issue with the Parallel Port. The USB Platform Cable is not affected by this problem; therefore, it can be used at 6 MHz.

  • Make sure there is no other software using the parallel port to access hardware. This could be in the form of a printer, dongle, or other software looking for hardware on the parallel port. 
  •  Change the cable speed in iMPACT operating on the cable by selecting Output -> Cable Setup.
  • If the problem is with the Parallel-IV cable, try connecting as a Parallel-III cable in the Cable Setup menu. 
  • Try using the 6.3.03 release of iMPACT.

If you are still experiencing problems, contact Xilinx Technical Support:

AR# 22293
日期 01/30/2018
状态 Active
Type 综合文章
People Also Viewed