UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 22871

7.1i PAR: "INFO:Par:252 - The MAP -timing placement will be discarded and your design will be placed using the command line options specified in PAR."

描述

Keywords: extra effort, -xe, Warning, 251

I ran my design through MAP with the -timing option, but when I run PAR with the -xe switch, I receive the following messages. This happens even if I specify -xe in my MAP command line.


"WARNING:Par:251 - Map -timing was run with a lower effort level setting than you are using for PAR. Xilinx recommends that you rerun Map -timing with the effort level that you have set in PAR to achieve better design performance.
INFO:Par:252 - The Map -timing placement will be discarded and your design will be placed using the command line options specified in PAR."

How can I make PAR keep the placement from MAP -timing?

解决方案

In the 8.1i software, the MAP -timing placement will be kept if the -xe option in the MAP command line has the same or higher effort level than in PAR.

For example,

map -p xc2vp2-fg256-7 -timing -ol high -xe n -t 1 -cm area -pr b -k 4 -tx off -o stopwatch_map.ncd stopwatch.ngd stopwatch.pcf

par -ol high -xe n -t 1 stopwatch_map.ncd stopwatch.ncd stopwatch.pcf

will not result in replacement.

In ISE 7.1is3 and later, you can also use the -p option in PAR to prevent the placer from running.
AR# 22871
日期 10/20/2008
状态 Archive
Type 综合文章
的页面