AR# 2335: Hardware Debugger M1.3: Cable Self Check fails or doesn't run specified number of cycles.
Hardware Debugger M1.3: Cable Self Check fails or doesn't run specified number of cycles.
Keywords: debug, cable, self, check, cycle
Cable Self Check does not seem to be working correctly. The specified "number of cycles" is set for 6, no matter what test is selected, a new dialog comes up which shows "number of cycles=1", passes=0,fails=1,yield=0.0. This usually means that the Test Header was not connected to the cable or power (VCC/GND) were not connected to the Test Header.
Insert the Test Header into the xchecker pod, and connect VCC and GND to the connectors "red" and "black" respectively.