We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 23794

8.2i ISE - Using Virtex-5 and Reentrant Route mode fails with "ERROR: <top_module>.ncd does not exist"


Keywords: place, MAP, implementation, possible cause

In a Virtex-5 project, the Place and Route Mode is set to Reentrant Route. When the implementation or Place and Route process is run, the following error occurs:

"Process "Map" completed successfully
ERROR: <top_module>.ncd does not exist
POSSIBLE CAUSE: you have selected to route without having placed the design.
Re-Run PAR by selecting one of the following:
- Normal Place and Route
- Place Only"


The problem is that Place and Route (PAR) is looking for a placed and routed NCD file when PAR has not yet been run on the design. To work around this issue, run PAR before setting the Place and Route Mode to Reentrant Route.

This problem has been fixed in the latest 8.2i Service Pack available at:
The first service pack containing the fix is 8.2i Service Pack 2.
AR# 23794
日期 04/16/2009
状态 Archive
Type 综合文章