General Description: Is it possible to add a company logo to a Foundation schematic onto the border or table? Some customer may want to add their own logo or graphics onto the schematic of a Foundation project.
This is possible if the logo or graphic is in the (.wmf) or Windows Metafile Format, without the header. A Windows Metafile can be created using programs such as Coreldraw.
To load the logo onto the schematic do the following:
From the schematic editor, select File->Table Setup, then in the Logo Metafile section you can browse to find the .WMF file. Click 'Apply', then 'OK'.
The logo will appear just above the Title Block in the lower right hand corner of the schematic sheet.
Note: The logo may become distorted from the tool forcing the graphic to fit into a pre-specified area.