We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 31110

ChipScope Pro - Instantiating VIO/ILA/ATC2 ChipScope Core results in "ERROR:NgdBuild:76"


When I instantiate a VIO/ILA/ATC2 ChipScope core in my design and implement, an error occurs similar to the following at the NGDBuild stage:

"ERROR:NgdBuild:76 - File "<file_path>/vio.ngc" cannot be merged into block "vio" (TYPE="vio") because one or morepins on the block, including pin "sync_out", were not found in the file."

How can I work around this error?


Signal bit-widths for ChipScope cores must be declared as vectors. For example, the signal "sync_out" should be declared as "wire [0:0] sync_out". Also, in the instantiation template for the VIO core, this convention must be used. The "vio.v" file generated from CORE Generator shows this in the module declaration, following this format should work around this error. If they are declared as just a std_logic or wire, "ERROR:NgdBuild:76" will occur at the Translate stage of implementation. This is because the core instantiation will not match up with the netlist.

For example, a one bit port "sync_out" would be declared as follows:

input [0:0] sync_out


sync_out : in std_logic_vector(0 downto 0);

AR# 31110
日期 01/02/2013
状态 Active
Type 综合文章
  • ChipScope Pro