AR# 32209

Embedded Tri-mode Ethernet MAC Wrapper (Virtex-4) v4.7 - Release Notes and Known Issues for ISE 11.1

描述

This Answer Record contains the Release Notes for the LogiCORE Embedded Tri-mode Ethernet MAC Wrapper v4.7 that was released in the ISE 11.1 and includes the following:  

 

- New Features 

- Bug Fixes 

- Known Issues  

 

For installation instructions, general CORE Generator known issues, and design tools requirements, see the IP Release Notes Guide at: 

http://www.xilinx.com/support/documentation/ip_documentation/xtp025.pdf

解决方案

New Features 

 

- ISE 11.1 software support 

 

Resolved Issues 

 

- For better timing closure, clock management for RGMII and GMII RX interfaces changed to use DCMs 

- (Xilinx Answer 32186) 16-bit 1000BASE-X Verilog RX FIFO could incorrectly overflow. 

 

Known Issues 

 

(Xilinx Answer 31860) Virtex-4, Virtex-5 Embedded Tri-Mode Ethernet MAC - Problems switching from 10/100 Mbps to 1G GMII operation 

(Xilinx Answer 30574) Embedded Tri-mode Ethernet MAC Wrapper (Virtex-4) - Loopback might fail in 1000BASE-X or SGMII mode 

(Xilinx Answer 32544) Embedded Tri-mode Ethernet MAC Wrapper (Virtex-4) v4.7 - Implementation of MII interface might fail in MAP due to IO banking rules 

(Xilinx Answer 33045) Embedded Tri-mode Ethernet MAC Wrapper (Virtex-4) v4.7 - When using SGMII example design failures are seen in implementation  

(Xilinx Answer 33456) Embedded Tri-Mode Ethernet MAC - The final byte of the Frame Check Sequence (FCS) is duplicated for some transmitted frames 

(Xilinx Answer 33386) 11.3 CORE Generator software - Licenses for certain free cores are now part of the software install

AR# 32209
日期 05/23/2014
状态 Archive
Type 综合文章