AR# 32321


10.1.03, System Generator for DSP - Why do I receive errors in behavioral simulation for port mismatches on my shared memory blocks?


When I create a shared memory which is either "read only" or "write only", I receive errors during behavioral simulation for port mismatches. Why?


This is because of a known issue where the additional ports are not properly connected when these modes are used. To work around this issue, set the shared memory block to "read and write" mode and tie the unused ports off to constant values. 


This issue is resolved in System Generator for DSP 11.1.

AR# 32321
日期 05/23/2014
状态 Archive
Type 综合文章
People Also Viewed