解决方案
1) INTRODUCTION
This file contains Release Notes for the Xilinx Virtex-5 FPGA GTX Transceiver Wizard v1.6. For the latest core updates, see the product page:
https://www.xilinx.com/content/xilinx/en/products/intellectual-property/v5_fpga_gtx_transceiver_wizard.html
2) NEW FEATURES
- Support for ISE Design Suite 11.2
- Clock correction sequence length options have been updated. Please refer to (Xilinx Answer 32164) for additional information.
- Fabric Clock Correction Module. When a 16-bit RX interface is selected with 8b10b decoding, a 1-byte clock correction sequence length is possible only through the use of the new CC_2B_1SKP module.
When a clock correction sequence length of 1-byte is selected on page 8 of the GUI, the Wizard generates one CC_2B_1SKP module for each GTX Transceiver in a tile.
Please refer to the "Virtex-5 FPGA RocketIO GTX Transceiver Clock Correction Module" (XTP037) for additional information regarding the module. - New directory structure for the generated example design. Please refer to the Getting Started Guide (UG204) for additional information:
https://www.xilinx.com/support/documentation/ip_documentation/v5_gtxwizard_gsg204.pdf
3) KNOWN ISSUES
- For some of the designs, timing closure at fabric rates of 312.5 MHz and higher might require significant effort. For best results, use a 16/20/32/40 bit interface for line rates higher than 2.5 Gb/s.
- When using RXRECCLK to generate RXUSRCLK/2, it is possible that the design will not meet timing. Please refer to (Xilinx Answer 32996) for more information.
- RST not held for 3 CLKIN cycles simulation warning. Please see (Xilinx Answer 32230) for more information.
- Might observe X's and timing simulation failures when doing back annotated simulation if using either the tx_sync deskew module or the fabric clock correction module.
- For 1-byte Example Design, X's might propagate from the GTX to user logic.
- Simulation warning related to the FIFO used in the external Clock Correction module. Please see (Xilinx Answer 33925) for more information.
- It is very difficult for the external Clock Correction module to meet timing at line rates above 5Gb/s and has not been verified to operate above that rate.
At rates greater than 5Gb/s, the operation of this module is not guaranteed or supported.
The most recent information, including known issues, work-arounds, and resolutions for this version is provided in the Release Notes Answer Record for the ISE Design Suite 11.2 IP Update at:
https://www.xilinx.com/support/documentation/ip_documentation/xtp025.pdf
4) CORE RELEASE HISTORY
Date By Version Description
================================================================================
06/24/2009 Xilinx, Inc. 1.6 ISE 11.2 Release, Fabric Clock Correction module
09/18/2008 Xilinx, Inc. 1.5 TXT support, Lane-to-lane Deskew module
06/27/2008 Xilinx, Inc. 1.4 OBSAI, PCIe Gen2, OOBDETECT_THRESHOLD update
04/25/2008 Xilinx, Inc. 1.3 Optimized CDR attributes
03/24/2008 Xilinx, Inc. 1.2 Initial release
================================================================================