UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 329

XACT 5.x Design Architect: calling up old design gives "cannot determine version" error

Description

Keywords: DA, Design Architect, error, version

Urgency: Standard

General Description:

After install XACT 5.x and the corresponding DS344 (Mentor interface), you
open a design containing components from the obsolete (pre-XACT 5.0)
libraries into Design Architect. While performing Check Sheet, Design
Architect errors similar to the following:

Error: Could not determine current version of ipad/part for instance I$480
Error: Could not determine current version of ipad/part for instance I$276
Error: Could not determine current version of opad/part for instance I$978

... and so on for each Xilinx component in the design.

解决方案

This is likely caused by directory references in the design no longer point
to the correct place where the obsolete libraries are stored. For example,
if you had installed the obsolete libraries (DS344 v1.10) at the path
/xact/ds344/v1.10, you would have initially set your $LCA environment
variable to point to /xact/ds344/v1.10. The XC4000 library would be placed
in /xact/ds344/v1.10/lib4k, so schematics using these libraries would then
contain references to $LCA/lib4k. (With this situation, the obsolete
libraries come up fine.)

Upon receiving DS344 v5.0, assume you installed it to /xact/ds344/v5.0. You
would then change $LCA to point to the new software at /xact/ds344/v5.0. The
library references in the design done with the obsolete libraries, however,
would still point to $LCA/lib4k. The problem is that $LCA is now set to
point to the new 5.0 software, which does not contain most of the obsolete
lib4k libraries. Thus, when Design Architect checks the schematic containing
the obsolete library parts, it can't verify them, because the don't exist in
the new $LCA tree.

The DS344 v5.0 install does NOT install the old libraries! The only
obsolete library that exists in the ds344 v5.0 install is the
lib4k/hard_macro library. This library was updated in version 5.0 in order
to support the translation of hard macros into relationally placed macros.

The solution is simply to copy the entire lib2k, lib3k, and lib4k
directories from the old directory tree to the new one, after moving the
lib4k/hard_macro directory in the old directory tree to a new location. In
this example, we would do:

mv /xact/ds344/v1.10/lib4k/hard_macro /home/joeuser/backup/hard_macro
cp -r /xact/ds344/v1.10/lib*k $LCA

NOTE: If you do not first move the old hard macro library before copying the
obsolete libraries into the new version 5 directory tree, you will overwrite
the new hard macro library!

If you plan on leaving the old software tree on the network, you can
alternatively create symbolic links in the new $LCA tree pointing to the
directories in the old directory: lib2k, lib3k and all subdirectories of
lib4k except for hard_macro.
AR# 329
创建日期 08/31/2007
Last Updated 10/01/2008
状态 Archive
Type 综合文章