We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 32950

11.1 PlanAhead - Why do I see infinite symbols as my slack value?


Why do I see infinite symbols as my slack value in PlanAhead?


The infinite symbol is shown on TIG constraints in PlanAhead. This is expected and desired behavior. When a TIG constraint is applied to a path, the slack on that path is truly infinite.  


In a timing report, TIG constraints do not show "Slack", but report "Delay". This is because "Slack" is considered for timing violations; whereas, "Delay" is used to make several assumptions about the design and perform a calculation on a false path so that the report can at least display the paths information.

AR# 32950
日期 05/23/2014
状态 Archive
Type 综合文章