AR# 34084

Serial RapidIO v5.4 - MMCM values incorrect for certain core settings in Virtex-6 devices

描述

In v5.4 of the Serial RapidIO Core, the settings used for the MMCM cause the VCO frequency to fall outside of the supported range which might result in excessive jitter and clocking problems.

This is fixed in v5.4 Rev1 of the core available in ISE 11.5.

解决方案

To work around this issue, upgrade to v5.4 Rev1 of the core and ISE 11.5, or perform the following:

Four attributes need to be changed in the MMCM instantiation which can be found inside the example_design/<core_name>_clk.v(hd) file. The four attributes are: DIVCLK_DIVIDE, CLKFBOUT_MULT_F, CLKOUT0_DIVIDE_F, and CLKOUT1_DIVIDE. The new correct values depend on the Transfer Frequency and Reference Clock Frequency being used. The table below lists the current incorrect values in v5.4 of the core and the correct values that the attributes should be modified to (marked in red).


链接问答记录

相关答复记录

Answer Number 问答标题 问题版本 已解决问题的版本
34019 ISE Design Suite 11.4.1 - Known Issues for Virtex-6 FPGA Service Pack N/A N/A
AR# 34084
日期 12/15/2012
状态 Active
Type 综合文章
器件 More Less
IP