AR# 38141

CoolRunner-II Timing - Bi-directional signals can have the wrong results in Timing Analyser

描述


When I look at the timing report for a Bi-Directional signal it appears to have passed, but when the delays are calculated it actually has failed.
Why is the failure not highlighted?

解决方案

This is a known issue. Following is an example of an incorrectly reported path:

Timing constraint: TS_TEST: FROM:TCK_G1:TO:TCK_G2:10.000nS

Slack: 6.500ns (requirement - data path)
Source: In_Pin
Destination: Out_Pin
Requirement: 10.000ns
Data Path Delay: 3.500ns (Levels of Logic = 6)

Data Path: In_Pin to Out_Pin
Location Delay type Delay(ns) Logical Resource(s)

In_Pin - 0.000 In_Pin
In_Pin.ZIA tIN + tHYS25 5.600 In_Pin.ZIA
Out_Pin.Q tLOGI1 + tLOGI2 + tPDI 2.300 Out_Pin.Q
Out_Pin tOUT + tOUT25 3.500 Out_Pin


The delay is listed as 3.5nS which gives a slack of 6.5nS, but the path is actually 5.6 + 2.3 + 3.5 = 11.4ns, so the constraint should have failed with a slack of -1.4nS.

To work around this issue,use the ASCII report (which correctly analyzes). The ASCII report can be generated by running the following in the command line:

taengine -f design_name .vm6 -detail
AR# 38141
日期 12/15/2012
状态 Active
Type 综合文章
器件