UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 38165

Digital Pre-Distortion (DPD) v3.0 - How do I drive the host interface?

Description

How do I drive the host interface?

解决方案


To communication with the host interface to read and write data, see the information below.

For writing to the DPD, a control mode trigger is required.

READ

To read the host interface, provide the address bus.

WRITE

To reset the coefficients (for example) perform the following:
  1. Write data 0x3 to address 1; --To reset coefficients
  2. Write data 0 to address 2; --Port number 0, there is only one path
  3. Write data 0 to address 0; -- Get ready to toggle the register
  4. Write data 0xABCDEF12 to address 0; --Toggle the register

For more information, refer to the DPD Host Interface Control Section section in the data sheet (DS767).

For a detailed list of Digital Pre-Distortion (DPD) Release Notes and Known Issues, see (Xilinx Answer 33521).
AR# 38165
创建日期 09/22/2010
Last Updated 11/18/2010
状态 Active
Type 综合文章
IP
  • Digital Pre-Distortion