You are using a deprecated Browser. Internet Explorer is no longer supported by Xilinx.
iMPACT - How to use Multiple USB Cable management in batch mode?
Multiple USB Cable management is available beginning with iMPACT version 10.1. How to use this feature in iMPACT batch mode?
From ISE 10.1 Service Pack 3, multiple USB cables can be controlled from an iMPACT batch (.cmd) file. Below is an example to switch between two different USB cablesattached tothe same computer:
setCable -port usb21 [-baud 750000]
readidcode -p 1
setCable -port usb22 [-baud 6000000]
assignfile -p 1 -file xxx
For how to run Multiple USB Cable management in iMPACT GUI, please refer to DS593 -> Multiple USB Cable Management:
More questions about Platform Cable USB are found at:
|Boards & Kits
- Platform Cable USB
- Platform Cable USB-II