AR# 38819

MIG v3.6, Spartan-6 MCB - Does the MCB support Dynamic ODT?

描述

Dynamic ODT is a new feature in DDR3 and enables the DRAM to switch between high or low termination impedance without issuing a mode register set command.

Dynamic ODT is typically used in multi-rank systems to terminate a rank to a low impedance value (30 or 40 Ohm) when in an idle condition and to a greater termination impedance when it is being accessed during a write operation.

解决方案

Because it is typically used in multi-rank systems, dynamic ODT is not supported by the Spartan-6 FPGA MCB.

链接问答记录

相关答复记录

Answer Number 问答标题 问题版本 已解决问题的版本
40778 MIG Spartan-6 MCB - Termination and I/O Standard Guidelines N/A N/A
AR# 38819
日期 08/14/2014
状态 Active
Type 综合文章
器件
IP