AR# 39076

MIG Virtex-6, Spartan-6 FPGA MCB - Disabling the DLL from a Micron memory DIMM

描述

I want to run the DDR3 on a lower clock speed than Xilinx offers. According to the FAQ from the Micron website, their DDR3 SDRAMs can work with the DLL on their component turned Off:
http://www.micron.com//support/faq/ddr3_sdram.html

Does the Xilinx MIG controller support this?

解决方案

No, MIG does not support disabling the DLL to run the controller at slower clock frequencies for any memory device or FPGA family.

NOTE: The MRS_DLL_RESET parameter in the MIG Virtex-6 RLDRAM II designs must be set to "DLL_ON" as turning this parameter Off is not supported.

链接问答记录

相关答复记录

AR# 39076
日期 11/19/2012
状态 Active
Type 综合文章
器件 More Less
IP