AR# 39288

Soft Error Mitigation Controller- Is the MCS file used for error correction by replace the same as the configuration bitstream?

描述

When error correction by replace is in use, an image of the configuration data is programmed to SPI memory.

Is this MCS data the same as the FPGA bitstream configuration data? Is it necessary to update the correction by replace data if the configuration bitstream is updated?

解决方案

The two files are very different. A bitstream is a packetized sequence of commands and data.The correction by replace data is not packetized, it is a flat dump of configuration frames.The two are related so if a new bitstream is created, you must change the correction by replace MCS file on the SPI flash.

Revision History
05/09/2011 - Added "Controller" to title
11/24/2010 - Initial Release
AR# 39288
日期 12/15/2012
状态 Active
Type 综合文章
IP