AR# 3955

F1.4, Simulator: Probes from schematic macro don't appear in Simulator.

描述

Keywords: Schematic, macro, simulate, current, probes

Urgency: Standard.

General Desciption:
After placing probes on a lower-level schematic-based macro, and then selecting "Simulate Current Macro" these probes do not appear in the simulator.

解决方案

This is a bug with the "Simulate Single Component" command. To workaround it, simply add the signals in the waveform viewer with the 'Add Signals' command (Signal -> Add Signals).
AR# 3955
日期 04/04/2000
状态 Archive
Type 综合文章