"> AR# 40685: MIG Spartan-6 MCB - JEDEC Specification

UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 40685

MIG Spartan-6 MCB - JEDEC Specification

描述

This section of the MIG Design Assistant focuses on the JEDEC Specification as it applies to the MIG Spartan-6 MCB designs. Below you will find information related to your specific question.

Note: This Answer Record is a part of the Xilinx MIG Solution Center(Xilinx Answer 34243). The Xilinx MIG Solution Center is available to address all questions related to MIG. Whether you are starting a new design with MIG or troubleshooting a problem, use the MIG Solution Center to guide you to the right information.

解决方案

The MIG Spartan-6 MCB controller completes a JEDEC standard compliant initialization sequence. The simulation testbench skips the initial 200 s delay to speed up simulation times. In hardware, this requirement is observed. The controller adheres to all timing parameters as defined by the JEDEC standards.

The following links provide additional detail regarding the MIG controller and various requirements regarding the JEDEC standards:

链接问答记录

相关答复记录

AR# 40685
日期 12/15/2012
状态 Active
Type 综合文章
器件
  • Spartan-6 LX
  • Spartan-6 LXT
IP
  • MIG
的页面