AR# 42114

|

13.1 PlanAhead - Fatal Error in Design Runs for PR Project

描述

Ihave a project that was created using Partial Reconfiguration in the 13.1 software.

In the Design Runs window, I reset two out of three runs and tried to run one of them.
Then, the fatal error message appears.

解决方案

To work aroundthe issue,make sure that you have the netlist design as well as the implemented design closed before you make changes to your design runs or before launching them.

This issue is fixed in the 13.2 PlanAhead tool.

AR# 42114
日期 05/19/2012
状态 Archive
Type 已知问题
Tools
People Also Viewed