AR# 42703

|

13.2 PlanAhead - DRC Error: Inconsistent port properties (PORTPROP)

描述

PlanAhead 13.2 software gives out the following DRC violation regarding drive strength.

 

Inconsistent port properties (PORTPROP)
Port ECM_DQ[32] has a drive strength (12), but its I/O standard (HSTL_II_T_DCI) does not allow the use of a drive strength


However, DRIVE constraints have not been specified in my source. 

In addition, implementation can complete successfully. 

Why does PlanAhead software report this error?
 
Will it cause any potential problems?

解决方案

The DRC message is correct--the ports' DRIVE constraints, which presents in the netlist do conflict with their IOSTANDARD constraints.

The problem is that the invalid DRIVE is being added by XST.

If the I/O standard is correct, it is safe to ignore the message as ISE's implementation tools will drop the bad DRIVE setting.

It will NOT affect the bitstream.
 
This issue has been resolved in ISE DS 13.3.
AR# 42703
日期 02/06/2015
状态 Archive
Type 已知问题
器件
Tools
People Also Viewed