AR# 46884

MIG v3.61 DDR2 - GUI doesn't allow selecting 72 bit data while interfacing with PPC440

描述

(UG086) (v3.6) September 21, 2010 DDR2 PPC440 supported features states that allowable data widths are 16, 32, 64 and 72.

The PPC440 option is enabled in the Memory selection page of the MIG GUI, and is selected as the memory type in the controller page components.

However the Data Width pull down does not show 72 bit as available.

解决方案

When the PPC440 option in the MIG tool is selected it limits the supported memory interface data widths to 16, 32 64 bit, and 72-bit with ECC.

When PPC440 is selected, it limits RDIMMs only for 72-bit data widths and components, UDIMM and SODIMM can be used for the other non-ECC data widths.

This is a limitation when selecting PPC440 rather than a limitation in the MIG GUI.

As a result, when you deselect PPC440 the 72 bit option becomes available.

Revision History:

01/21/2015 - Initial Release

本答复记录是否对您有帮助？

AR# 46884
日期	01/23/2015
状态	Active
Type	综合文章
器件	Virtex-5
IP	MIG

的页面

AR# 46884

MIG v3.61 DDR2 - GUI doesn't allow selecting 72 bit data while interfacing with PPC440

描述

解决方案

应用

产品

开发者专区

技术支持

关于 Xilinx