You are using a deprecated Browser. Internet Explorer is no longer supported by Xilinx.
Foundation F1.5: SC caused a GPF in module SC_LIBR.DLL when saving symbol
When using the Foundation Symbol Editor in F1.5 to modify the pins on a symbol,
the following error may occur:
SC caused a GPF in module SC_LIBR.DLL at <hex address>.
The symbol has been saved correctly but the General Protection Fault causes
Foundation to close. The GPF does not occur each time the Symbol Editor is
This has also been seen when updating an HDL macro from the HDL Editor, when
the editor has been opened via the schematic.
This problem has been resolved in Foundation F1.5i. Please upgrade to this
new release when possible.