UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 50735

MIG 7 Series DDR3/DDR2 - vio_instr_mode_value 0x1 and 0xE do not work properly

描述

Version Found: v1.2
Version Resolved and other Known Issues: See (Xilinx Answer 45195).

The Traffic Generator does not send the expected commands when setting "vio_instr_mode_value" to 0x1 or 0xE. As defined in UG586, Table 1-13, 0x1: Command type (read/write) as defined by fixed_instr_i, and 0xE: Write only at address zero, however, read only commands will be sent.

解决方案

Users are required to upgrade to the latest version of MIG if these instruction modes are required, as there is no workaround available.

Revision History
07/25/2012 - Initial release of AR

AR# 50735
日期 01/16/2013
状态 Active
Type 已知问题
器件
  • Artix-7
  • Kintex-7
  • Virtex-7
IP
  • MIG 7 Series
的页面