AR# 51282: LogiCORE IP Ten Gigabit Ethernet PCS/PMA (10GBASE-R/10GBASE-KR) v2.4 - Updates needed to reset/initialization logic for cable pull/ RX data input not present
AR# 51282
|
LogiCORE IP Ten Gigabit Ethernet PCS/PMA (10GBASE-R/10GBASE-KR) v2.4 - Updates needed to reset/initialization logic for cable pull/ RX data input not present
描述
If targeting 7 series FPGAs with the Ten Gigabit Ethernet PCS/PMA (10GBASE-R/10GBASE-KR) v2.4 core, updates are needed to the reset/initialization logic for the core and GT, if the core will be operating in a system where there could be a cable unplug, a link partner reset, or other cause for no RX data to be present at the serial input to the GT. Failures include not establishing a link or FCS errors at the MAC level.
解决方案
The attached rev2 update resolves: - Issues seen in hardware on cable unplug or reset resulting in failure to establish a link or FCS errors at the MAC level - BASE-KR Training not completing after reset (Xilinx Answer 51312)
Include in the rev2 update are the previous rev1 updates: - Improved hot-plug capabilities - Separation of the tx and rx resets in the example design and block level - Updates to improve timing closure in Vivado (Xilinx Answer 50809) - Connection of signal_detect port to core FSMs
The v2.4 rev2 core is preproduction and hardware testing continues.
To install the patch, follow the instructions in the included readme file.
本答复记录是否对您有帮助?
AR# 51282
日期
08/21/2012
状态
Active
Type
综合文章
IP
10 Gigabit Ethernet PCS-PMA with FEC/Auto-Negotiation for backplanes (10GBASE-KR)