AR# 51412

Project Navigator - Passing gen2, PCIEx4 parameters to a reference design in ISE Project Navigator

描述

I am trying to run the TRD in ISE GUI mode with slight modifications. I am experiencing someproblems while doing so. Isuspect that the problems I am experiencing are due to thethat fact that unlike using the batch file, I am not passing the parameters of the design being a x4, gen 2 design, and I do not know how the ISE toolis resolving this.

How can I ensure that my design is being built as a 4-lane, gen2 PCIe design?

解决方案

You can pass the parameters gen2 and PCIEx4 in Synthesis propertiesas follows.

Go to Synthesis-> Process Properties -> Synthesis Options -> -define. Set define to PCIEx4, GEN2_CAP as shown in the below snapshot:

PCIeParamter.png
AR# 51412
日期 12/18/2012
状态 Active
Type 综合文章
Tools More Less