We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 5158

NGDANNO 1.5: FATAL_ERROR:basut:basutblist.c:348:1.2-Maximum iterator count exceeded


Keywords: basut, ngdanno, iterator, count, basutblist, pcf

Urgency: Standard

General Description: When running ngdanno with the following
command line:
ngdanno -p <name>.pcf <name>.ncd <name>.ngm
the following error may be observed:
FATAL_ERROR:basut:basutblist.c:348:1.2 - Maximimum iterator
count exceeded. Please call Xilinx support.


The workaround is to run ngdanno without using the .pcf file if it is
not needed. as stated below:

From Dynatext->Developement System Reference Guide->
Chapter 15 NGDAnno-> NGDAnno options->

-p (PCF File)
-p pcf_file.pcf
The -p option allows you to specify a PCF (Physical Constraints) file
as input to NGDAnno. You only need to specify a constraints file if it
contains the following:

--Level information (CMOS or TTL) for IOBs in a 4000E or 4000EX design
--Prorating constraints

Prorating constraints and prorated delays are described in the
"OFFSET Timing Specifications" section of the "Using Timing Constraints"
AR# 5158
日期 06/13/2002
状态 Archive
Type ??????