AR# 52570

14.2/2012.2 Data2mem - After running Data2mem on a Bitstream for a 2000T, configuration will fail with an IDCODE error on SLR0

描述


Configuration fails on a 2000T device after Data2mem has been run on the Bistream. Reading back the Device Status Register with iMPACT will show the following -

'1': Reading SLR0 bootsts register contents...
[0] VALID_0 - ERROR OR END OF STARTUP (EOS) DETECTED : 1
[1] FALLBACK_0 - FALLBACK TRIGGERED RECONFIGURATION : 0
[2] IPROG_0 - INTERNAL WARMBOOT (IPROG) TRIGGERED RECONFIGURATION : 0
[3] WTO_ERROR_0 - WATCHDOG TIME OUT ERROR : 0
[4] ID_ERROR_0 - FPGA DEVICE IDCODE ERROR : 1
[5] CRC_ERROR_0 - CYCLIC REDUNDANCY CHECK (CRC) ERROR : 0
[6] WRAP_ERROR_0 - BPI FLASH ADDRESS COUNTER WRAP AROUND ERROR : 0
[7] HMAC_ERROR_0 - HMAC ERROR : 0
[8] VALID_1 - ERROR OR END OF STARTUP (EOS) DETECTED : 0
[9] FALLBACK_1 - FALLBACK TRIGGERED RECONFIGURATION : 0
[10] IPROG_1 - INTERNAL WARMBOOT (IPROG) TRIGGERED RECONFIGURATION : 0
[11] WTO_ERROR_1 - WATCHDOG TIME OUT ERROR : 0
[12] ID_ERROR_1 - FPGA DEVICE IDCODE ERROR : 0
[13] CRC_ERROR_1 - CYCLIC REDUNDANCY CHECK (CRC) ERROR : 0
[14] WRAP_ERROR_1 - BPI FLASH ADDRESS COUNTER WRAP AROUND ERROR : 0
[15] HMAC_ERROR_1 - HMAC ERROR : 0

...

..

.'1': Reading SLR0 status register contents...
[0] CRC ERROR : 0
[1] DECRYPTOR ENABLE : 0
[2] PLL LOCK STATUS : 1
[3] DCI MATCH STATUS : 1
[4] END OF STARTUP (EOS) STATUS : 0
[5] GTS_CFG_B STATUS : 0
[6] GWE STATUS : 0
[7] GHIGH STATUS : 0
[8] MODE PIN M[0] : 0
[9] MODE PIN M[1] : 1
[10] MODE PIN M[2] : 1
[11] INIT_B INTERNAL SIGNAL STATUS : 1
[12] INIT_B PIN : 0
[13] DONE INTERNAL SIGNAL STATUS : 0
[14] DONE PIN : 0
[15] IDCODE ERROR : 1
[16] SECURITY ERROR : 0
[17] SYSTEM MONITOR OVER-TEMP ALARM STATUS : 0
[18] CFG STARTUP STATE MACHINE PHASE : 0
[19] CFG STARTUP STATE MACHINE PHASE : 0
[20] CFG STARTUP STATE MACHINE PHASE : 0
[21] RESERVED : 0
[22] RESERVED : 0
[23] RESERVED : 0
[24] RESERVED : 0
[25] CFG BUS WIDTH DETECTION : 1
[26] CFG BUS WIDTH DETECTION : 0
[27] HMAC ERROR : 0
[28] PUDC_B PIN : 1
[29] BAD PACKET ERROR : 0
[30] CFGBVS PIN : 0
[31] RESERVED : 0

How do I work around this issue?

解决方案

This issue is released in ISE Design Suite 14.2/Vivado 2012.3

AR# 52570
日期 11/02/2012
状态 Archive
Type 综合文章
器件
Tools