AR# 53134


7 series - Can CFGBVS be connected by a pull-up resistor?


During board layout, CFGBVS was accidentially connected to Vcco_0 with a pull-up resistor rather than connected directly as recommended in the 7 Series Configuration User Guide.

Is this an issue?


CFGBVS only requires that the pin reach the expected signal switching level relative to Vcco_0.

1k or stronger is expected to be fine.

AR# 53134
日期 03/05/2013
状态 Active
Type 综合文章
People Also Viewed