UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 53261

Serial RapidIO v5.5 - LREQ-IS is not sent if the core receives PR and PNA at the same time

描述

Version Found: v5.5

When the Serial RapidIO v5.5 core receives a Packet Not Accepted (PNA) control symbol immediately after a Packet Retry (PR) control symbol, the core does not send an LREQ-Input status in reply to the PNA. It sends only Restart-From-Retry (RFR) control symbol. However, the core starts the LRESP time-out counter and goes into the fatal error state after timing out for not receiving the LRESP.

解决方案

This is a known issue that can occur if the 'Additional Link Requests Before Fatal' value in the core configuration GUI is set to "1".

To work around this problem, select a value greater than "1" for this parameter.

NOTE: "Version Found" refers to the version where the problem was first discovered. The problem might also exist in earlier versions, but no specific testing has been performed to verify earlier versions.

Revision History
12/03/2012 - Initial release

链接问答记录

主要问答记录

Answer Number 问答标题 问题版本 已解决问题的版本
35157 Serial RapidIO v5.5 - Release Notes and Known Issues for ISE 12.1 Design Tools N/A N/A
AR# 53261
日期 12/03/2012
状态 Active
Type 已知问题
IP
  • Serial RapidIO
的页面