We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 53960

14.x EDK, ChipScope - Is Cross Triggering enabled on Zynq and how is it done?


How do you configure the cross triggering between software and hardware (ChipScope) debug?

The debug configuration GUI in XPS tells me that there is no processor found that can co-debug with this IBA interface.

On the general settings GUI of the Zynq tab, I can enable the cross triggering signals of the Zynq PS, but the debug configuration GUI apparently does not recognize or cannot use these. Can I connect them manually, or how is this supposed to work?


Cross Trigger is not supported in 14.x, however, support should be added in 2013.1.

AR# 53960
日期 06/03/2013
状态 Active
Type 综合文章
  • Zynq-7000