AR# 55192


MIG 7 Series - Using the ChipScope tool in Vivado Design Suite


In the Vivado 2013.1 Design Suite, the ChipScope tool is being replaced with the Vivado Logic Analyzer. However, MIG does not yet support using Vivado Logic Analyzer, so users must continue using the ChipScope tool for debugging purposes.


The Vivado 2013.1 Design Suite still supports ChipScope cores, and the MIG example design with the debug signals enabled can be created and used by following these steps:

  1. Create your Vivado project.
  2. Locate MIG 7 Series from the IP Catalog.
  3. Right-click MIG 7 Series and choose "Customize IP...".
  4. Enable the Debug Signals for Memory Controller (ON), select the rest of the options, and click "Generate".
  5. Right-click the MIG XCI file located in the sources window and choose "Generate Output Products...".
  6. Generate select all output products that have not been generated and click OK.
  7. Right-click the MIG XCI file located in the sources window and choose "Open IP Example Design".
  8. Select Sub-direction location and click OK.
  9. Once the Example Design is created and opened in a new Vivado project window, you are now ready to run through synthesis, implementation, and bitstream generation.
  10. After bitstream generation the *.bit file can be used in ChipScope standalone.


Revision History
05/07/2013 - Updated to include debug option
04/03/2013 - Initial release



Answer Number 问答标题 问题版本 已解决问题的版本
54025 MIG 7 Series - IP Release Notes and Known Issues for Vivado N/A N/A
AR# 55192
日期 06/05/2013
状态 Active
Type 综合文章
People Also Viewed