AR# 56293


LogiCORE IP Serial RapidIO Gen2 v3.1 - SRIO Gen2 v3.1 Rev2 Patch


This answer record contains the SRIO Gen2 v3.1 Rev2 patch. 

The patch incorporates fixes for the following two issues:

Feature Addition:

  - Added 7 series GTH support.

Issue Addressed:

  - Fixed Critical warning issue due to incorrect "create clock" constraint in the ooc.xdc file.

  - Fixed TXDIFFCTRL signal bit width issue.


The following steps must be taken to install the patch:

  1. Prior to installing this update, the Serial RapidIO Endpoint Gen2 v2.0 must be installed. 

    To obtain this version, install Vivado 2014.1 available at: 

    This update requires the use of Vivado 2014.1 or later.

  2. Unzip the archive to your Xilinx installation directory.

    Your Xilinx path variable points to this location.

    The archive will ask to overwrite existing files. Please select "Yes to All" and allow it to overwrite these files.

    If it does not ask you to replace files, verify that you are installing it to the correct location as pointed to by the Xilinx path variable. 

    For further information on finding the Xilinx install and using the environment variable, see (Xilinx Answer 11630).

Note: You might need to have a system administrator install the patch if you do not have write permissions to the Xilinx Install directory.


文件名 文件大小 File Type
xilinx_answer_56293_srio_gen2_v3_1rev2.rar 3 MB RAR
AR# 56293
日期 06/09/2014
状态 Active
Type 综合文章
People Also Viewed