UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 5788

NGDBuild - "ERROR:based:58 - On or above line 890 in file "repic.edf" occurs when I use a Synplify netlist

Description

Keywords: Synplicity, Synplify, 5200, NGDBuild, EDIF, XNF

Urgency: Standard

General Description:
When I target an XC5200 family using Synplicity 5.0.8 or earlier, the following error occurs in NGDBuild:

"ERROR:based:58 - On or above line 890 in file "repic.edf": Bad portRef "I5" in net "U2_inst_repic_code_slow_flashZ0". This likely means that the EDIF netlist was improperly written. Please contact the vendor of the program that produced this EDIF file."

解决方案

This happens if Synplify generates an EDIF as a netlist.

To avoid this problem, use XNF instead of EDIF for an XC5000 flow.
AR# 5788
创建日期 03/03/1999
Last Updated 11/06/2003
状态 Archive
Type 综合文章