AR# 58195

MIG 7 Series QDRII+ - Cypress memory models give erroneous data set up and hold violations with any simulator

描述

Version Found: v2.0 Rev1
Version Resolved: See (Xilinx Answer 54025)

Cypress memory models give erroneous simulation results with VCS and Vivado Simulator. 

The following warning messages can be seen:

WARNING - "/proj/ipmig/trivedi/XSIM_QDR_ISSUE/XSIM_QDRII_CALIB_FAIL/SN2269_v7qdriiplus_native_245MHz_xsim_18bit_x2/coregen/project_1/example_project/mig_7series_v2_0_example/mig_7series_v2_0_example.srcs/sources_1/ip/mig_7series_v2_0/mig_7series_v2_0/example_design/sim/CY7C2562XV18.v" Line 1059: Timing violation in scope sim_tb_top.COMP_INST[0].QDR2PLUS_MEM at time 100000 ps $setuphold<hold> (A:100000 ps, K_n:100000 ps, 275000 ps)
WARNING - "/proj/ipmig/trivedi/XSIM_QDR_ISSUE/XSIM_QDRII_CALIB_FAIL/SN2269_v7qdriiplus_native_245MHz_xsim_18bit_x2/coregen/project_1/example_project/mig_7series_v2_0_example/mig_7series_v2_0_example.srcs/sources_1/ip/mig_7series_v2_0/mig_7series_v2_0/example_design/sim/CY7C2562XV18.v" Line 1049: Timing violation in scope sim_tb_top.COMP_INST[0].QDR2PLUS_MEM at time 100000 ps $setuphold<hold> (BW0_n:100000 ps, K_n:100000 ps, 275000 ps)
WARNING - "/proj/ipmig/trivedi/XSIM_QDR_ISSUE/XSIM_QDRII_CALIB_FAIL/SN2269_v7qdriiplus_native_245MHz_xsim_18bit_x2/coregen/project_1/example_project/mig_7series_v2_0_example/mig_7series_v2_0_example.srcs/sources_1/ip/mig_7series_v2_0/mig_7series_v2_0/example_design/sim/CY7C2562XV18.v" Line 1050: Timing violation in scope.

NOTICE : 020 : Address bus corruption on K_n 0
NOTICE : 020 : BWS0 problem on K_n 0
NOTICE : 020 : BWS1 problem on K_n 0
NOTICE : 013 : D problem on K
NOTICE : 014 : D problem on K_n
qdr_phy_top.v: phy_ctl_ready asserted 1400930000
TEST FAILED: INITIALIZATION DID NOT COMPLETE

解决方案

Data hold and set up violations can be seen from the model during compilation.

This is due to K clock movement in calibration.

This is an issue with the Cypress QDRII+ memory model and not with VCS or Vivado Simulator.

The errors do not affect calibration results and can be safely ignored.


AR# 58195
日期 10/15/2014
状态 Active
Type 已知问题
器件
IP