AR# 60527


MIG 7 Series - Virtex-7 HT - Error is generated when trying to open the MIG 7 Series tool when targeting a part with an flg package - Failed to generate custom UI outputs


Version Found: MIG 7 Series v2.0 Rev3
Version Resolved: See (Xilinx Answer 54025)

An error is issued when trying to open MIG 7 Series to customize a memory interface for the following devices:

  • xc7vh580t-flg1155
  • xc7vh580t-flg1931
  • xc7vh870t-flg1932

The exact error is:

Failed to generate custom UI outputs.

This error is generated because while Vivado in 2014.1 added support for these FLG package parts, MIG does not yet support them.


These parts will be supported by MIG 7 Series in Vivado 2014.3.  

To work around this until then, please generate a MIG design targeting a compatible device.  

The design can then be used to target the FLG packages. 

The compatible parts are as follows:

  • xc7vh580t-flg1155 -> xc7vh580t-hcg1155
  • xc7vh580t-flg1931 -> xc7vh580t-hcg1931
  • xc7vh870t-flg1932 -> xc7vh870t-hcg1932                                                                                                                        


AR# 60527
日期 05/27/2014
状态 Active
Type 已知问题
People Also Viewed