UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!
  1. Xilinx -灵活应变. 万物智能.
  2. 技术支持
  3. AR# 60978: Zynq-7000 SoC - QSPI Controller Reports Wrong “Busy Status” Of Flash Memories In Dual Parallel Configuration When Auto CS And “Divide by 2” Baud Rate Is Used

AR# 60978

Zynq-7000 SoC - QSPI Controller Reports Wrong “Busy Status” Of Flash Memories In Dual Parallel Configuration When Auto CS And “Divide by 2” Baud Rate Is Used

描述

When the QSPI controller is in dual parallel mode and issues a read status (RDSR) command to external flash memory devices using TXD2, the controller should combine the Write-In-Progress (WIP) bit from both flash devices by OR'ing them and reporting the result as the final status.

However, when the QSPI controller Manual_CS is set to auto mode and BAUD_RATE_DIV is divide by 2, it only reports the status of the lower device.

Therefore, the status is incorrect if the lower memory is ready and upper memory is still busy.

This is a third-party errata; this issue will not be fixed.

解决方案

 

Impact:   Major. Under the described condition, the QSPI controller in dual parallel mode can fail an operation on the lower memory when a prior write operation to the lower memory takes longer than the upper memory.

Work-around:           Set Manual_CS to manual mode instead of auto mode or use a BAUD_RATE_DIV other than 2.

Configurations Affected:       All Zynq devices using the QSPI controller in dual parallel mode with the settings listed in the description section.

 

Device Revision(s) Affected: All, no plan to fix. 

AR# 60978
日期 08/26/2014
状态 Active
Type 已知问题
器件
的页面